RENOPLAN SYSTEM 2

How can a barrier be made against subfloor moisture and high residual moisture in cement-based substrates? With UZIN PE 480.

Long waiting times due to damp substrates, and the high associated drying costs, are a problem especially where there are time pressures. The 2-component epoxy moisture barrier is not only for priming and strengthening but is also especially suitable for damp-proofing cement-based substrates. Combined with UZIN PE 280 a super-fast primer, a reliable barrier is formed against very high moisture content in concrete floors or cement screeds. Before application, any pools or standing water must be completely removed.

 

 

<p>Punch several times through the plastic plug
and floor of the upper section of the combican
using a metal spike (or screw-driver).
Do not forget to wear protective clothing!</p>

Punch several times through the plastic plug and floor of the upper section of the combican using...

<p>Allow the liquid hardener to drain completely
into the resin container.</p>

Allow the liquid hardener to drain completely into the resin container.

<p>Mix both components in the can using a drill
with mixer attachment until streak-free. Then
pour this mixture into a clean, empty container
and thoroughly mix again.
   </p>

Mix both components in the can using a drill with mixer attachment until streak-free. Then pour...

<p>Immediately apply an even coat of the UZIN
PE 480 using a B1 notched trowel. Now roll
over again with the UZIN nylon fibre roller.
The UZIN Epoxy Accelerator can be added
to UZIN PE 480 to accelerate the drying.
Please observe the corresponding product
data sheets.</p>

Immediately apply an even coat of the UZIN PE 480 using a B1 notched trowel. Now roll over again...

<p>Apply the Super-Fast Primer UZIN PE 280
to create a rough surface. Apply a thin,
even coat of primer over the whole substrate
using a UZIN nylon fibre roller. The levelling
compound can be applied after 60 minutes
because UZIN PE 280 is quick drying.*</p>

Apply the Super-Fast Primer UZIN PE 280 to create a rough surface. Apply a thin, even coat of...

<p>Mix UZIN NC 170 levelling compound with
clean, cold water. For mixing, use a highperformance, WOLFF Power-X 900 mixer.</p>

Mix UZIN NC 170 levelling compound with clean, cold water. For mixing, use a highperformance,...

<p>Spread the UZIN NC 170 levelling compound
onto the prepared surface. As an alternative
to the hand-trowel, a screed-rake can also
be used. For this, the Large Surface Rake
from the UZIN range is recommended.</p>

Spread the UZIN NC 170 levelling compound onto the prepared surface. As an alternative to the...

* At 20 °C and 65 % relative humidity.